Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
- Running gear and steering
   Removal and installation of stupichny assembly of a forward suspension bracket
   Replacement of bearings of forward naves
   Removal, major maintenance and installation of the bottom lever of a forward suspension bracket
   Removal and installation of the bottom spherical support of a forward suspension bracket
   Removal and installation of components of the stabilizer of cross-section stability of a forward suspension bracket
   Removal and installation of assemblies of racks / hydraulic blocks of a forward suspension bracket
   Removal and installation of the proof-reader of height of a road gleam of a forward suspension bracket
   Removal and installation of a stretcher of a forward suspension bracket
   Removal and installation of naves of back wheels
   Replacement of back stupichny bearings
   Removal and installation of longitudinal levers of a back suspension bracket
   Removal and installation of assembly of the back bridge
   Removal and installation of hydraulic blocks of a back suspension bracket
   Removal and installation of the proof-reader of a road gleam of a back suspension bracket
   Check of installation and adjustment of a road gleam
   Removal and installation of a steering wheel
   Removal, check of a condition of components and installation of a steering column
   Removal and installation of assembly of the switch of the ignition/lock of a steering column
   The steering mechanism - general information, removal, major maintenance and installation
   System of hydrostrengthening of a wheel - general information
   Removal and installation of tips of steering drafts
   Corners of installation of wheels - the general information, check and adjustment of convergence of forward wheels
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Removal and installation of the proof-reader of height of a road gleam of a forward suspension bracket

Removal

At the corresponding complete set new sealing couplings of shtutserny sockets of hydraulic tubes be required.


 PERFORMANCE ORDER

1. Dump pressure in hydraulic system (see. Head Uniform hydraulic system).
2. To Poddomkratta the car also establish it on props
3. Mark the adjusting provision of hydraulic tubes, then disconnect them from assembly of the proof-reader of a road gleam. Get under assembly of the proof-reader suitable drain capacity and disconnect hydraulic tubes. At once закупорьте the open ends of tubes and unions of their connection for the purpose of minimization of losses of liquid and in order to avoid hit in dirt system.

4. Turn out bolts of fastening of the proof-reader and liberate driving rods from the executive lever of assembly, remembering adjusting provisions of components. Take assembly of the proof-reader from under the car.
1 — two hydraulic tubes
2 — fastening bolts

Installation

Regenerative repair of the proof-reader of height of a road gleam is not obviously possible. In case of a device exit out of operation make replacement it assembled.

Installation is made upside-down. Pay attention to the next moments:
   a) Track correctness of connection and reliability of fastening of hydraulic tubes, at the corresponding complete set do not forget to replace sealing couplings of shtutserny sockets;
   b) Do not forget to grease spherical hinges of driving rods before connection them to the executive lever of the proof-reader;
   c) After car lowering on the earth tighten spuskny the gate of a regulator of pressure and transfer a control lever a suspension bracket to the situation "Maximum";
   d) Check level of hydraulic liquid, in case of need make the corresponding adjustment (address to Head Routine maintenance);
   e) In summary check installation of a road gleam (see. Check of installation and adjustment of a road gleam).