Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
- Running gear and steering
   Removal and installation of stupichny assembly of a forward suspension bracket
   Replacement of bearings of forward naves
   Removal, major maintenance and installation of the bottom lever of a forward suspension bracket
   Removal and installation of the bottom spherical support of a forward suspension bracket
   Removal and installation of components of the stabilizer of cross-section stability of a forward suspension bracket
   Removal and installation of assemblies of racks / hydraulic blocks of a forward suspension bracket
   Removal and installation of the proof-reader of height of a road gleam of a forward suspension bracket
   Removal and installation of a stretcher of a forward suspension bracket
   Removal and installation of naves of back wheels
   Replacement of back stupichny bearings
   Removal and installation of longitudinal levers of a back suspension bracket
   Removal and installation of assembly of the back bridge
   Removal and installation of hydraulic blocks of a back suspension bracket
   Removal and installation of the proof-reader of a road gleam of a back suspension bracket
   Check of installation and adjustment of a road gleam
   Removal and installation of a steering wheel
   Removal, check of a condition of components and installation of a steering column
   Removal and installation of assembly of the switch of the ignition/lock of a steering column
   The steering mechanism - general information, removal, major maintenance and installation
   System of hydrostrengthening of a wheel - general information
   Removal and installation of tips of steering drafts
   Corners of installation of wheels - the general information, check and adjustment of convergence of forward wheels
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Check of installation and adjustment of a road gleam

Check

After each moving of a body and each measurement made during described below procedure the car it is necessary to roll away a little forward-back by rotation of one of driving wheels for the purpose of removal of the tension arising in components of a suspension bracket.


 PERFORMANCE ORDER

1. Check pressure of a rating of tires, in case of need make the corresponding adjustment.
2. Lift the car on a platform.
3. Transfer a suspension bracket to "Normal" situation.
4. Release the parking brake.
5. Start the engine.
6. From below push the car up with hands, then release: the body should shake down, then rise and be stabilized.
7. Determine height of a road gleam by a forward axis from both parties of the car for what measure distance between the plane of contact of wheels with a platform and the bottom surface of a stretcher on a site passing along axes of power shafts. As control parameter arithmetic-mean value of two removed measurements undertakes.
8. Operating in a similar manner, determine height of a road gleam by a back suspension bracket. In this case the distance from the bearing plane of a platform to the bottom surface of back rubber pillows of support of a suspension bracket is measured, then arithmetic-mean value of two removed measurements is calculated.
9. Compare results of check to requirements of Specifications.

Adjustment

Adjustment of a road gleam is made by means of special tools and it is necessary to charge its performance to specialists of car-care center.