Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
- Running gear and steering
   Removal and installation of stupichny assembly of a forward suspension bracket
   Replacement of bearings of forward naves
   Removal, major maintenance and installation of the bottom lever of a forward suspension bracket
   Removal and installation of the bottom spherical support of a forward suspension bracket
   Removal and installation of components of the stabilizer of cross-section stability of a forward suspension bracket
   Removal and installation of assemblies of racks / hydraulic blocks of a forward suspension bracket
   Removal and installation of the proof-reader of height of a road gleam of a forward suspension bracket
   Removal and installation of a stretcher of a forward suspension bracket
   Removal and installation of naves of back wheels
   Replacement of back stupichny bearings
   Removal and installation of longitudinal levers of a back suspension bracket
   Removal and installation of assembly of the back bridge
   Removal and installation of hydraulic blocks of a back suspension bracket
   Removal and installation of the proof-reader of a road gleam of a back suspension bracket
   Check of installation and adjustment of a road gleam
   Removal and installation of a steering wheel
   Removal, check of a condition of components and installation of a steering column
   Removal and installation of assembly of the switch of the ignition/lock of a steering column
   The steering mechanism - general information, removal, major maintenance and installation
   System of hydrostrengthening of a wheel - general information
   Removal and installation of tips of steering drafts
   Corners of installation of wheels - the general information, check and adjustment of convergence of forward wheels
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Removal and installation of assembly of the switch of the ignition/lock of a steering column

Removal

 PERFORMANCE ORDER

1. Execute the procedures described in the section Removal, check of a condition of components and installation of a steering column (the subsection Removal", subitem 1 — 7).
2. Under a steering column find two contact sockets of electroconducting of the switch of ignition and disunite them. Liberate wires from intermediate clamps.

3. Turn out the fixing screw in a back part of zamkovy assembly.

4. Insert into the lock the ignition key and turn it in average situation between labels "And" and “S”.

5. A small screw-driver with a flat sting wring out a lock uvula of a fixing clamp.

6. For a key extend zamkovy assembly from the casing.

Installation

Installation is made upside-down. Pay attention to the next moments:
   a) Track reliability of a zashchelkivaniye of a lock uvula of a fixing clamp;
   b) Before establishing casings of a steering column make sure of serviceability of functioning of its lock;
   c) The description of procedure of installation of a steering wheel is provided in the section Removal and installation of a steering wheel.