Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
- Running gear and steering
   Removal and installation of stupichny assembly of a forward suspension bracket
   Replacement of bearings of forward naves
   Removal, major maintenance and installation of the bottom lever of a forward suspension bracket
   Removal and installation of the bottom spherical support of a forward suspension bracket
   Removal and installation of components of the stabilizer of cross-section stability of a forward suspension bracket
   Removal and installation of assemblies of racks / hydraulic blocks of a forward suspension bracket
   Removal and installation of the proof-reader of height of a road gleam of a forward suspension bracket
   Removal and installation of a stretcher of a forward suspension bracket
   Removal and installation of naves of back wheels
   Replacement of back stupichny bearings
   Removal and installation of longitudinal levers of a back suspension bracket
   Removal and installation of assembly of the back bridge
   Removal and installation of hydraulic blocks of a back suspension bracket
   Removal and installation of the proof-reader of a road gleam of a back suspension bracket
   Check of installation and adjustment of a road gleam
   Removal and installation of a steering wheel
   Removal, check of a condition of components and installation of a steering column
   Removal and installation of assembly of the switch of the ignition/lock of a steering column
   The steering mechanism - general information, removal, major maintenance and installation
   System of hydrostrengthening of a wheel - general information
   Removal and installation of tips of steering drafts
   Corners of installation of wheels - the general information, check and adjustment of convergence of forward wheels
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Removal and installation of a steering wheel

Models without a safety cushion

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Having accurately hooked, remove the central overlay of a steering wheel.
3. At the corresponding complete set disconnect electroconducting from a payment of remote control by functioning of the radio tape recorder located in a groove in the top part of a steering wheel.
4. Give a fixing nut and remove a steering wheel from a column shaft (at the corresponding complete set track electroconducting liberation from the central part of a wheel).

Installation

Installation is made upside-down. At the corresponding complete set track correctness of laying of electroconducting. A fixing nut tighten with demanded effort.

The models equipped with a safety cushion

The electronic control unit (ECU) of a safety cushion is built in in assembly of a steering wheel, - try not to damage the block in the course of dismantle of the last.

Removal

 PERFORMANCE ORDER

1. Remove the safety cushion module (address to Head Onboard electric equipment).

2. At the corresponding complete set disconnect electroconducting from a payment of remote control by functioning of the radio tape recorder established in a groove in the top part of a steering wheel.

3. Liberate the contact socket of electroconducting of a safety cushion from a clamp on a steering wheel and disunite it.

4. Give a nut of fastening of a steering wheel. In the course of removal of a wheel from a shaft of a steering column track an electroconducting prodevaniye through its stupichny part.

5. Transfer the removed steering wheel to a storage place. Try not to damage safety cushion ECU.

Installation

Installation is made upside-down. Pay attention to the next moments:
   a) Track correctness of laying of electroconducting;
   b) Track observance of demanded effort of a tightening of a nut of fastening of a steering wheel;
   c) Do not forget to establish into place the safety cushion module (address to Head Onboard electric equipment).