Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   + start and charge Systems
   + ignition System - petrol models
   + preheat System - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Диван на кухню со спальным местом недорого по материалам http://www.divan-na-kuhniu.ru.

Engine electric equipment

Specifications

Start and charge systems

General parameters

System type

12-V, with grounding on a negative pole

Battery

Type

Fulmen, Delco or Steco

Target tension depending on charge level

In

Low level of a charge

12.5

Normal level of a charge

12.6

Good level of a charge

12.7

Generator

Type

Valeo or Mitsubishi (Melco) (depending on model)

Maximum current, And

75 or 92

Adjustable tension

In

Hot engine

13.8 ÷ 14.5

Cold engine

14.2 ÷ 14.8

Minimum admissible length of brushes, mm

10

Starter

Firm manufacturer

Valeo or Bosch (depending on model)

Type

Except models with the RFY engine (16 valves)

Bosch 0001 107 019 or Valeo D6RА 66

Models with the RFY engine (16 valves)

Valeo D6RА 51

Ignition system - petrol models

General parameters

System type

Static (without the distributor), under control of ECU of a control system by the engine

Ignition order

1-3-4-2

Installation of a corner of an advancing of ignition

ECU (see the text) is supervised

Resistance of windings of the coil ignitions (Magneti-Marelli 8É system)

Ohm

Primary windings

0.8

Secondary windings

   •  Bosch coil

14 000

   •  Sagem coil

7 100

   •  Valeo coil

8 600

Preheat system - diesel models

Efforts of a tightening of carving connections, Nanometer

Glow plugs

22