Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
- Body and salon furnish
   Care of components of a body and car bottom
   Care of an upholstery and salon carpets
   Repair of insignificant damages of body panels
   Repair of seriously damaged body panels
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal, installation and cowl adjustment
   Removal and installation of a driving cable of an otpuskaniye of the lock of a cowl
   Removal and installation of locks of a cowl
   Removal, installation and adjustment of doors
   Removal and installation of panels of an internal upholstery of doors
   Removal and installation of door handles and lock components
   Removal and installation of regulators of window regulators of door windows
   Removal, installation and adjustment of a door of a back and its telescopic emphasis
   Removal and installation of components of the lock of a door of a back
   Removal and installation of components of the uniform lock
   Removal and installation of components of the electric drive of door window regulators
   Removal and installation of door rear-view mirrors and accompanying components
   Windscreen, glass of a door of a back and the other fixed glasses - the general information
   The top hatch - the general information
   External body furnish
   Removal and installation of seats
   Removal and installation of seat belts
   Removal and installation of elements of internal furnish of salon
   Removal and installation of the central console
   Removal and dashboard installation
   Control body sizes
+ Onboard electric equipment
+ electric equipment Schemes



Removal and installation of elements of internal furnish of salon

Casings of a steering column

Removal

 PERFORMANCE ORDER

1. Remove steering wheels (address to Head the Running gear and a steering).

2. Turn out two screws under a steering column and remove the top casing of the last.

3. Turn out the right screw of fastening of the bottom casing to a ledge on column assembly.

4. Remove the bottom casing from a column, then liberate from it a rheostat of management of intensity of illumination of the dashboard and disconnect electroconducting. Remove a casing.

Installation

Installation is made upside-down.

Panels of an internal upholstery of doors

See. Removal and installation of panels of an internal upholstery of doors.

Panels of internal furnish of salon and luggage compartment

For fastening of panels screws and various type clamps are used. The order of removal of panels is usually quite obvious.

Carpet

For facing of a floor two sections of a carpet are used. Sections fasten to floor panels by means of screws or clamps. Usually the same fixture is used for fixing of interfaced panels of furnish of walls of salon.

Removal of a carpet is not connected with any special difficulties is however interfaced to considerable temporary expenses as demands preliminary removal of seats, the central console, anchor knots of seat belts and interfaced vertical panels of furnish.

Ceiling upholstery

The ceiling upholstery fastens to a car roof by means of clamps. For removal of a ceiling upholstery it is necessary to dismantle previously such elements of the equipment of salon, as poruchnevy handles, sun-protection peaks, various finishing panels, and also sealing strips of doorways and an aperture of the top hatch.

It is necessary to notice that dismantle of a ceiling upholstery demands from the performer of certain skills and is connected with risk of damage of an obivochny material, and therefore, it will be reasonable to charge its performance to specialists of car-care center.