Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
- Body and salon furnish
   Care of components of a body and car bottom
   Care of an upholstery and salon carpets
   Repair of insignificant damages of body panels
   Repair of seriously damaged body panels
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal, installation and cowl adjustment
   Removal and installation of a driving cable of an otpuskaniye of the lock of a cowl
   Removal and installation of locks of a cowl
   Removal, installation and adjustment of doors
   Removal and installation of panels of an internal upholstery of doors
   Removal and installation of door handles and lock components
   Removal and installation of regulators of window regulators of door windows
   Removal, installation and adjustment of a door of a back and its telescopic emphasis
   Removal and installation of components of the lock of a door of a back
   Removal and installation of components of the uniform lock
   Removal and installation of components of the electric drive of door window regulators
   Removal and installation of door rear-view mirrors and accompanying components
   Windscreen, glass of a door of a back and the other fixed glasses - the general information
   The top hatch - the general information
   External body furnish
   Removal and installation of seats
   Removal and installation of seat belts
   Removal and installation of elements of internal furnish of salon
   Removal and installation of the central console
   Removal and dashboard installation
   Control body sizes
+ Onboard electric equipment
+ electric equipment Schemes



Removal and installation of components of the uniform lock

Electronic control unit

Removal

The block is located under the central console.

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove the central console (see. Removal and installation of the central console).

3. Liberate the block from a basic arm and disconnect from it electroconducting.

Installation

Installation is made upside-down.

Door activators

Activators of the uniform lock are built in zamkovy assemblies of doors (see. Removal and installation of door handles and lock components).

Activator of the lock of a door of a back

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Open a back door.
3. Open hatches of access and disconnect electroconducting from the back combined lamps built in a door.
4. Release clamps, turn out fixing screws and remove the panel of the bottom furnish of a door of a back.

5. Turn out two fixing bolts.

6. Take the activator of the door lock, then disconnect from it electroconducting.

7. Installation is made upside-down.

The receiver of signals from a remote control

 PERFORMANCE ORDER

1. Having accurately hooked, remove the panel of a cover of the electromotor of a drive of the top hatch.

2. Release clamps and remove the receiver of signals of the DU panel of the uniform lock from the cover panel, disconnect electroconducting.

3. Installation is made upside-down.

DU panel batteries

 PERFORMANCE ORDER

1. Turn out the small self-cut screw in a back part of assembly of the transmitter. Extend the transmitter from a back cover for the purpose of ensuring access to batteries.
2. Take batteries (try to remember their correct adjusting situation).
3. Correctly establish two new batteries, establish into place a cover and tighten саморез.