Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   - Start and charge systems
      Diagnostics of malfunctions of electric equipment
      Check of a condition and battery charging
      Removal and installation of the storage battery
      Check of serviceability of functioning of system of a charge
      Removal, installation and adjustment of a tension of a belt of a drive of the generator
      Removal and generator installation
      Dismantling and generator assembly, check of a condition of internal components
      Check of serviceability of functioning of components of system of start
      Removal and starter installation
      Check of serviceability of functioning and starter repair
      Removal and installation of the switch of ignition
      Removal and installation of the sensor switch of a control lamp of pressure of oil
      Removal and installation of the sensor of level of impellent oil
      Removal and installation of the sensor of temperature of impellent oil
   + ignition System - petrol models
   + preheat System - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Removal and generator installation

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Weaken a belt of a drive of auxiliary units (address to Head Routine maintenance) and throw off it from a generator pulley.

3. At the corresponding complete set remove protective rubber caps from generator plugs, then release terminal nuts and disconnect electroconducting from a back part of the generator.

4. Give a bolt/nut of fastening of the generator to the top basic arm. Pay attention that if for fastening of the generator the long through bolt is used, there is no need for its full reversing: will weaken only it enough. On some models for the purpose of ensuring access to fixture of the generator it is necessary to remove an intermediate pulley / a tension roller of a driving belt.

5. On diesel models take clamps of fastening of the filter of a cover and remove the last for the purpose of ensuring access to the top fixing bolt.

6. Remove the generator from basic arms and take it from an impellent compartment.

Installation

Installation is made upside-down. Track correctness of laying and adjustment of a tension of a driving belt (address to Head Routine maintenance). Make sure of reliability of a tightening of fixture of the generator and its basic arms.