Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   - Start and charge systems
      Diagnostics of malfunctions of electric equipment
      Check of a condition and battery charging
      Removal and installation of the storage battery
      Check of serviceability of functioning of system of a charge
      Removal, installation and adjustment of a tension of a belt of a drive of the generator
      Removal and generator installation
      Dismantling and generator assembly, check of a condition of internal components
      Check of serviceability of functioning of components of system of start
      Removal and starter installation
      Check of serviceability of functioning and starter repair
      Removal and installation of the switch of ignition
      Removal and installation of the sensor switch of a control lamp of pressure of oil
      Removal and installation of the sensor of level of impellent oil
      Removal and installation of the sensor of temperature of impellent oil
   + ignition System - petrol models
   + preheat System - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes
best canadian mail order pharmacies



Removal and installation of the sensor switch of a control lamp of pressure of oil

Removal

 PERFORMANCE ORDER

1. The sensor switch is established in a lobby of the block of cylinders, over a support of the oil filter. For the purpose of ensuring access to the sensor switch firmly cock the parking brake, then поддомкратьте a front of the car and establish it on props.
2. Disconnect a negative wire from the battery.
3. At the corresponding complete set remove the protective coupling from the shtekerny socket, then disconnect from the sensor switch electroconducting.
4. Turn out the sensor switch from the block of cylinders and remove a sealing washer. Prepare for collecting spilled oil. An opening at once закупорьте in order to avoid hit in the dirt engine.

Installation

 PERFORMANCE ORDER

1. Check a condition of a sealing washer. In case of detection of defects make replacement.
2. Screw the sensor switch with a washer on the regular place and tighten it with demanded effort. Restore initial connection of electroconducting.
3. If lifted, lower the car on the earth, then check level of impellent oil. In case of need make the corresponding adjustment (address to Head Routine maintenance).