Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
- Engine repair
   - The repair procedures which are not demanding extraction of the engine from the car - petrol engines
      Check of kompressionny pressure in cylinders
      Fixing cranked / distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of a gas-distributing belt
      Belt of a drive of GRM - the general information, removal and installation
      Removal, check of a condition and installation of a natyazhitel and cogwheels of a gas-distributing belt
      Epiploon replacement (ов) camshaft
      Removal, check of a condition and installation of a camshaft and pushers of valves
      Check and adjustment of klapanny gaps
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a maslookhladitel (model of 2.0 l)
      Replacement of epiploons of a cranked shaft
      Removal, check of a condition and flywheel installation / driving disk
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + the Repair procedures which are not demanding extraction of the engine from the car - diesel engines
   + Removal and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes



Epiploon replacement (ов) camshaft

If are going to make replacement of an epiploon of a camshaft without removal of a gas-distributing belt, before check the last on existence of traces of pollution of oil (the greasy belt is subject to replacement without fail). Now take care of that that in the course of epiploon replacement oil did not get on a belt - wrap up the last rags. If the belt is removed, before its installation carefully wipe all components of a drive of GRM and adjacent surfaces of a block/head, having completely cleared them of oil traces.


 PERFORMANCE ORDER

1. Remove a camshaft cogwheel (see. Removal, check of a condition and installation of a natyazhitel and cogwheels of a gas-distributing belt).
2. Puncture or drill in a face surface of an epiploon pair of small openings the friend opposite to the friend. Screw in openings саморезы and, having grasped heads of the last nippers, take an epiploon from the nest.
3. Wipe a casing of an epiploon and remove teases and the agnails, capable to bring to failure of a new epiploon.
4. Grease sponges of a new epiploon with pure impellent oil and plant an epiploon in the nest against the stop in a special coat hanger. As an opravka for landing of an epiploon it is possible to use a replaceable face head of the corresponding size or a piece of a pipe of suitable diameter. Opravka should rest only against the firm external region of an epiploon. Try not to allow damages of sponges.

The epiploon is established by sponges inside.

5. Establish into place a camshaft cogwheel (see. Removal, check of a condition and installation of a natyazhitel and cogwheels of a gas-distributing belt).