Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
- Engine repair
   - The repair procedures which are not demanding extraction of the engine from the car - petrol engines
      Check of kompressionny pressure in cylinders
      Fixing cranked / distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of a gas-distributing belt
      Belt of a drive of GRM - the general information, removal and installation
      Removal, check of a condition and installation of a natyazhitel and cogwheels of a gas-distributing belt
      Epiploon replacement (ов) camshaft
      Removal, check of a condition and installation of a camshaft and pushers of valves
      Check and adjustment of klapanny gaps
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a maslookhladitel (model of 2.0 l)
      Replacement of epiploons of a cranked shaft
      Removal, check of a condition and flywheel installation / driving disk
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + the Repair procedures which are not demanding extraction of the engine from the car - diesel engines
   + Removal and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes



Removal and installation of a cover of a head of cylinders

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

2. Release fixing collars and disconnect from the right first line of a cover of a head of cylinders ventilating hoses. The firm collars of braided type established at manufacturer should be cut off and at assembly to replace more practical screw or worm.

3. Release a collar and disconnect from a forward wall of a cover of a head of cylinders connecting air purifier with the throttle case an air inlet sleeve. Also disconnect an air inlet brought to the left edge of a cover.

4. Release two clamps, then turn out two located in front of fixing the screw and remove from a cover of a head of cylinders an air purifier cover. Take filtering element and put it aside together with an air purifier cover.

5. In stages evenly weaken ten fixing nuts and uncover heads of cylinders.

6. Remove also sealing laying of a cover. Attentively study a laying condition, in case of detection of mechanical defects or signs of aging of a material make replacement.

Installation

 PERFORMANCE ORDER

1. Carefully smooth out and wipe interfaced surfaces of a head of cylinders and its cover, having completely removed from them oil traces.
2. Lay rubber sealing laying in a flute on a head of cylinders, having tracked correctness of its landing on all length.

3. Grease with suitable hermetic of a cover of bearings since both ends of a camshaft in places of their joining with an interfaced surface of a cover of a head of cylinders.

4. Accurately, trying not to displace laying, lay a cover of a head of cylinders on the engine.

5. Having made sure that laying is not displaced, screw fixing nuts and in stages evenly tighten them in a demanded order with the set effort.

6. Establish into place filtering element and an air purifier cover. Strongly tighten fixing screws and latch clamps.
7. Connect to a cover of a head of cylinders ventilating hoses and air sleeves and reliably fix them fixing collars.
8. Connect a negative wire to the battery.