Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm devices
   Replacement of lamps of internal lighting devices
   Removal and installation of external lighting and alarm devices
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and lighter installation
   Alarm system “do not forget to switch off lighting devices” - the general information
   Removal and installation of a horn of a horn
   Removal and installation of a driving cable of the speedometer/sensor of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of the electromotor and drafts of a drive of a cleaner of a windscreen
   Removal and installation of the electromotor of a drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and radio tape recorder installation
   Removal and installation of loudspeakers
   Removal and installation of the aerial of a radio receiver
   Anticreeping system - the general information
   Safety cushion - the general information, precautionary measures and system deactivation
   Removal and installation of components of a safety cushion
   Diagnostics of systems of electronic control
+ electric equipment Schemes



Adjustment of optical axes of head headlights

Exact adjustment of optical axes of head block headlights is made by means of the special equipment in the conditions of a car-care center workshop.

Approximate control is made by rotation by a prutkovy key of the adjusting screws located on the upper edge of each of block headlights.

 PERFORMANCE ORDER

1. Open a cowl and make necessary adjustment, rotating the corresponding adjusting screw through an opening of the panel of a front (pay attention that is simpler to steal up to the external screw from the back party of a block headlight if near at hand there is no rather long prutkovy key). The external screw serves for correction of provision of a block headlight in the horizontal plane, internal - in vertical.
A — Screws of adjustment of horizontal provision of a block headlight
B — Screws of adjustment of vertical provision of a block headlight