Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm devices
   Replacement of lamps of internal lighting devices
   Removal and installation of external lighting and alarm devices
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and lighter installation
   Alarm system “do not forget to switch off lighting devices” - the general information
   Removal and installation of a horn of a horn
   Removal and installation of a driving cable of the speedometer/sensor of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of the electromotor and drafts of a drive of a cleaner of a windscreen
   Removal and installation of the electromotor of a drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and radio tape recorder installation
   Removal and installation of loudspeakers
   Removal and installation of the aerial of a radio receiver
   Anticreeping system - the general information
   Safety cushion - the general information, precautionary measures and system deactivation
   Removal and installation of components of a safety cushion
   Diagnostics of systems of electronic control
+ electric equipment Schemes


Removal and installation of the electromotor of a drive of a back screen wiper

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Open a back door.
3. Open a cover of access and disconnect electroconducting from the back combined lamps built in at a door.
4. Release fixing clamps / turn out screws and remove the bottom panel of an internal upholstery of a door of a back.
5. Having hooked, remove a protective cap of a shpindelny nut of the lever of a screen wiper, disconnect from a spindle the socket of a hose of supply of washing liquid.
6. Give a nut and remove the lever from a spindle.

7. Give a nut of fastening of a spindle and remove a plastic cover and a sealant.

8. Disconnect from the union on the back party of the driving electromotor a hose of supply of washing liquid.

9. Disunite two contact sockets of electroconducting on assembly of the driving motor.

10. Turn out four fixing bolts.

11. Remove driving assembly.

12. At desire the electromotor can be removed from driving assembly after an otdavaniye of a nut of fastening (A) of its spindle to draft, and also three bolts of fastening (B) of the motor.

Installation

Installation is made upside-down.