Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm devices
   Replacement of lamps of internal lighting devices
   Removal and installation of external lighting and alarm devices
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and lighter installation
   Alarm system “do not forget to switch off lighting devices” - the general information
   Removal and installation of a horn of a horn
   Removal and installation of a driving cable of the speedometer/sensor of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of the electromotor and drafts of a drive of a cleaner of a windscreen
   Removal and installation of the electromotor of a drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and radio tape recorder installation
   Removal and installation of loudspeakers
   Removal and installation of the aerial of a radio receiver
   Anticreeping system - the general information
   Safety cushion - the general information, precautionary measures and system deactivation
   Removal and installation of components of a safety cushion
   Diagnostics of systems of electronic control
+ electric equipment Schemes


Removal and installation of the aerial of a radio receiver

Aerial mast

The mast is simply turned out from the basis of antenna assembly.

Antenna cable

 PERFORMANCE ORDER

1. For ensuring access to the top end of antenna assembly give a nut of fastening of its basis. It is necessary to remove a ceiling upholstery therefore it will be reasonable to charge performance of procedure to the expert (address to Head the Body and salon furnish).
2. Having provided access to the aerial basis, give a nut and disconnect a cable.
3. The cable is laid across a roof of the car and goes down under the dashboard on the right forward body rack. For ensuring access to intermediate clamps of fastening of a cable, probably, it is necessary to remove "Torpedo" (address to Head the Body and salon furnish).
4. Remove assembly of a radio tape recorder and disconnect an antenna cable from its back panel.
5. Try to remember a route of laying of a cable.
6. Installation is made upside-down.