Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
- Systems of cooling, heating
   Detachment and replacement of hoses of system of cooling
   Removal, check of a condition and radiator installation
   Removal, check of serviceability of functioning and thermostat installation
   Check of serviceability of functioning, removal and fan installation (ов) cooling systems
   Check of serviceability of functioning, removal and installation of electric switches and sensors of system of cooling
   Removal and installation of the water pump
   Removal and installation of a casing of the thermostat / fuel filter (diesel models)
   System of heating/ventilation of salon - the general information
   Removal and installation of components of system of heating/ventilation of salon
   Air central air - the general information and precautionary measures
   Removal and installation of components of central air of air
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes



Removal, check of a condition and radiator installation

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

2. On models with the coal adsorber established in an impellent compartment execute the following procedures:
   a) To Otboltita clamping level of fastening of the battery;
   b) Give two top bolts and the bottom nut of fastening of an assembly bracket of a coal adsorber to the body panel;
   c) Disconnect from an adsorber and its electromagnetic valve hoses and electroconducting;
   d) Accurately shift adsorber assembly aside, having released space for radiator removal.

3. Release collars and disconnect from a radiator the top and bottom hoses.
4. At the corresponding complete set disconnect electroconducting from the thermosensitive sensor switch of the fan of system of the cooling, established assembly on a radiator.

5. Wring out two clamps, located on the top corners of a radiator, then incline a radiator back for the purpose of ensuring access to two connected to the right bottom corner of assembly to hoses.



6. Release collars and disconnect the remained hoses.
7. Take a radiator from an impellent compartment.

Condition check

 PERFORMANCE ORDER

1. If the suspicion in violation of passableness of a radiator became the reason of removal, it is necessary to make its obratnopotochny washing (address to Head Routine maintenance). By means of a soft brush (do not cut about edges of plates fingers) or the compressed air (do not forget to put on goggles) clean gaps between plates of the heat exchanger of a radiator.

Remember that fragile plates of the heat exchanger of a radiator at careless handling can be easily damaged!

2. In case of need at car repair shop it is possible to make "line" check of a radiator on existence of blocking of internal channels.
3. Repair of the radiator which has lost tightness should be carried out only in the conditions of a specialized workshop.
4. In an extreme situation of leakage of cooling liquid from a radiator it is possible to suspend by means of special hermetic without radiator extraction from the car (see instructions on hermetic application).
5. Before sending a radiator in repair, disconnect from it all hoses and remove the thermosensitive sensor switch of the fan.
6. Check a condition of rubber pillows of support of a radiator. In case of need make replacement.

Installation

Installation is made upside-down. Pay attention to the next moments:
   a) Track correctness of installation of rubber pillows of the bottom support of a radiator;
   b) Track correctness of gearing of uvulas of big hoses in grooves of reception branch pipes of a radiator;
   c) In summary do not forget to make filling of system of cooling (address to Head Routine maintenance).