Citroen Xantia

since 1993 of release

Repair and car operation

Citroen Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   - Routine maintenance of the car - petrol models
      Regular service
      Replacement of impellent oil and oil filter
      Check of a condition of hoses, and identification of sources of leaks
      Check of adjustment of coupling
      Check of level of ATF
      Suspension bracket and steering drive
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with To/in)
      Check of a condition of a coolant of central air of air
      Replacement of spark plugs
      Check of a condition of system of ignition
      Check and adjustment of turns and quality of a mix of idling
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a condition and replacement of a belt of a drive of auxiliary units
      Greasing of the mechanism of a drive of switching off of coupling
      Check of a condition of blocks of brake mechanisms of lobbies and back wheels
      Check of serviceability of functioning and adjustment of the parking brake
      Trial runs
      AT transmission liquid replacement
      Greasing of locks and loops
      Replacement of a filtering element of an air purifier
      Check of level of transmission oil (model with RKPP)
      Replacement of the fuel filter
      Replacement of hydraulic LHM liquid and returnable filter
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of a drive of GRM
      Replacement of cooling liquid
   + Routine maintenance of the car - diesel models
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

AT transmission liquid replacement



1. Make on the car a short trip during which transmission should be heated-up to normal working temperature.
2. Park the car on an equal horizontal platform, whenever possible with a firm covering. Switch off ignition and cock the parking brake. For the purpose of ensuring access prop up protivootkatny boots back wheels, then поддомкратьте a front of the car and establish it on props. For check and correction of level the ATF car should be again transferred to horizontal situation.

3. Take measuring щуп and get under transmission drain capacity suitable on volume. The case of transmission is equipped with two drain jams: one is screwed in the pallet, the second - in the lower part of a case of differential.

Remember that merged liquid is warmed up to very essential temperature - accept precautionary measures against an oshparivaniye!

4. Turn out both drain stoppers and lower all contents of a case of transmission in drain capacity. Wipe drain jams, with special care having removed metal sawdust from a magnetic insert. Without fail replace sealing washers.
5. After the liquid effluence from transmission will stop, smooth out a carving of drain jams and openings in a case. Screw and strongly tighten drain jams, previously without having forgotten to supply them with new sealing washers. Return the car to horizontal situation.
6. Filling in transmission of fresh ATF is made in the small portions through directing tube measuring щупа. Use the equipped close-meshed grid a funnel. Watch, that in a case of AT no extraneous subjects got. Before adding the next portion of liquid wait some time, sufficient for distribution of already filled in ATF in cavities between internal components of a box. Each time check liquid level
7. After level of ATF will reach a point the MOVE on an edge щупа, establish the last on a regular place. Start the engine and let's to it work on single turns within several minutes. Again muffle the engine and repeat check of level of ATF, in case of need make the corresponding adjustment. Make on the car a short trip for the purpose of final distribution of liquid on internal cavities of a transmission. Repeat check.