Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of blocks of disk brake mechanisms of back wheels
   Condition check, removal and installation of brake disks
   Removal, major maintenance and installation of supports of disk brake mechanisms of forward wheels
   Removal, major maintenance and installation of supports of disk brake mechanisms of back wheels
   Removal, major maintenance and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   The parking brake - general information and adjustments
   Removal and installation of a control lever of the parking brake
   Removal and installation of cables of a drive of the parking brake
   Removal and installation of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of system of anti-blocking of brakes
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes



Removal and installation of a control lever of the parking brake

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove the central console (address to Head the Body and salon furnish).

3. At the corresponding complete set liberate the control unit of the uniform lock from a bearing arm on a salon floor. On the models equipped with natyazhitel of seat belts, shift an arm aside for the purpose of ensuring access to nuts of fastening of a control lever of the parking brake, - try not to allow tensions of electroconducting of the control unit natyazhitel.

4. Disconnect driving cables of the parking brake from supports of brake mechanisms (see. Removal and installation of cables of a drive of the parking brake).
5. Liberate from an arm behind control lever assembly the sensor switch of a control lamp of raising of the parking brake, disconnect the corresponding electroconducting.

6. Disconnect from a control lever primary cable of a drive of the parking brake.

7. Give three fixing nuts and remove assembly of a control lever of the parking brake.

Installation

Installation is made upside-down. Having finished lever installation, check adjustment of a drive of the parking brake (see. The parking brake - general information and adjustments).