Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   + Routine maintenance of the car - petrol models
   - Routine maintenance of the car - diesel models
      Regular service
      Replacement of impellent oil and oil filter
      Check of a condition of hoses, and identification of sources of leaks
      Water removal from the fuel filter
      Check of adjustment of coupling
      Check of level of ATF
      Suspension bracket and steering drive
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with To/in)
      Check of a condition of a coolant of central air of air
      Check and adjustment of turns of idling and prevention spontaneous останова engine
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a condition and replacement of a belt of a drive of auxiliary units
      Greasing of the mechanism of a drive of switching off of coupling
      Check of serviceability of functioning and adjustment of the parking brake
      Trial runs
      Replacement of the fuel filter
      AT transmission liquid replacement
      Check of a condition of blocks of brake mechanisms of lobbies and back wheels
      Greasing of locks and loops
      Replacement of hydraulic LHM liquid and returnable filter
      Replacement of a filtering element of an air purifier
      Check of level of transmission oil (model with RKPP)
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of a drive of GRM
      Replacement of cooling liquid
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Check of a condition of protective covers of power shafts

THROUGH EACH 10 000 KM (6000 MILES) RUN OR TIMES IN 12 MONTHS

 PERFORMANCE ORDER

1. To Poddomkratta the car also establish it on props. Turn out a wheel against the stop and slowly rotate a forward wheel, visually estimating a condition of a rubber protective cover of the external CV JOINT of a power shaft, periodically opening folds гофра. Existence of cracks, gaps and traces of aging of a material can lead to development of leakages of the greasing fraught with hit of moisture and dirt in the hinge and premature wear of the last. Estimate reliability of fastening of a cover metal bandage tapes. Repeat check for the external CV JOINT of the second power shaft, then estimate a condition of internal CV JOINTS. Defective covers are subject to replacement without fail (see. Head Power shafts).

2. At the same time it is necessary to estimate the general condition actually hinges for what grasp a power shaft and try повращать a wheel (the external CV JOINT), then undertake the internal CV JOINT and try повращать a shaft. Existence a little appreciable люфта testifies to wear of the corresponding hinge / шлицов pins of a power shaft or weakening of a fixing nut.