Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   + Routine maintenance of the car - petrol models
   - Routine maintenance of the car - diesel models
      Regular service
      Replacement of impellent oil and oil filter
      Check of a condition of hoses, and identification of sources of leaks
      Water removal from the fuel filter
      Check of adjustment of coupling
      Check of level of ATF
      Suspension bracket and steering drive
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with To/in)
      Check of a condition of a coolant of central air of air
      Check and adjustment of turns of idling and prevention spontaneous останова engine
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a condition and replacement of a belt of a drive of auxiliary units
      Greasing of the mechanism of a drive of switching off of coupling
      Check of serviceability of functioning and adjustment of the parking brake
      Trial runs
      Replacement of the fuel filter
      AT transmission liquid replacement
      Check of a condition of blocks of brake mechanisms of lobbies and back wheels
      Greasing of locks and loops
      Replacement of hydraulic LHM liquid and returnable filter
      Replacement of a filtering element of an air purifier
      Check of level of transmission oil (model with RKPP)
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of a drive of GRM
      Replacement of cooling liquid
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Check of level of ATF

THROUGH EACH 10 000 KM (6000 MILES) RUN OR TIMES IN 12 MONTHS

 PERFORMANCE ORDER

1. Make on the car a short trip, having warmed up transmission to normal working temperature. Be parked on an equal horizontal platform, whenever possible with a firm covering. Check of level of transmission liquid is made by means of special measuring щупа, the impellent compartment located in a forward part, directly ahead of the engine block. The handle top щупа for simplification of searches is usually painted in bright color.

2. Leave the engine working at single turns and transfer the AT selector lever to the situation "R". Take щуп from a directing tube and dry wipe its edge pure rags or a paper towel. Fill щуп back, having planted it in a tube against the stop, then again take. By size of the moistened site of an edge determine ATF level, - it should be between the top and bottom marks щупа.

3. In case of need make the corresponding adjustment, having added demanded amount of liquid through directing tube щупа. For convenience use a funnel.

Watch, that level of ATF did not rise above the top mark.

4. Having finished adjustment, make on the car a short trip for the purpose of ATF distribution on surfaces of internal components of transmission, then repeat level check. In case of need add missing amount of liquid.
5. Watch, that liquid level constantly was in transmission between the bottom and top marks in an edge measuring щупа. Remember that the lack of ATF can lead to serious internal damages of transmission.
6. Need of frequent performance of correction of level of ATF testifies to development of the leaks which source should be immediately revealed, and the reason is eliminated.