Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   + Routine maintenance of the car - petrol models
   - Routine maintenance of the car - diesel models
      Regular service
      Replacement of impellent oil and oil filter
      Check of a condition of hoses, and identification of sources of leaks
      Water removal from the fuel filter
      Check of adjustment of coupling
      Check of level of ATF
      Suspension bracket and steering drive
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with To/in)
      Check of a condition of a coolant of central air of air
      Check and adjustment of turns of idling and prevention spontaneous останова engine
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a condition and replacement of a belt of a drive of auxiliary units
      Greasing of the mechanism of a drive of switching off of coupling
      Check of serviceability of functioning and adjustment of the parking brake
      Trial runs
      Replacement of the fuel filter
      AT transmission liquid replacement
      Check of a condition of blocks of brake mechanisms of lobbies and back wheels
      Greasing of locks and loops
      Replacement of hydraulic LHM liquid and returnable filter
      Replacement of a filtering element of an air purifier
      Check of level of transmission oil (model with RKPP)
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of a drive of GRM
      Replacement of cooling liquid
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Replacement of the fuel filter

THROUGH EACH 30 000 KM (18 000 MILES) RUN

Components of the fuel filter

1 — a cover Bolt
2 — a filter Cover

3 — the Filtering element
4 — the Drain gate


 PERFORMANCE ORDER

1. The fuel filter is concluded in a plastic casing and located in a forward part of the power unit (see an illustration Components of the fuel filter ).

2. At the corresponding complete set cover a dome of coupling with a polyethylene film for the purpose of protection of internal components against contact to following fuel.
3. Get capacity suitable on volume under a drain hose of the fuel filter. Turn out the drain gate in a forward part of a casing of the filter and completely let out fuel.

4. Strongly tighten the drain gate, then give four fixing screws and remove from a filter casing the top cover.

5. Take filtering element from a casing. Track, that the rubber sealing ring acted in film together with a filtering element, instead of remained stuck to an end face to a casing/cover.

6. Carefully wipe internal surfaces of a casing, having completely cleared them of traces of dirt and extraneous particles. Establish a replaceable filtering element. Track existence on the regular place of a sealing ring.
7. Grease a carving part of screws of fastening of a cover with fixing hermetic. Establish a cover on a casing, screw and strongly tighten screws.
8. Fill a power supply system with fuel (see. A power supply system - diesel models).
9. Open the drain gate and wait while the stream of pure transparent fuel will not start to follow from a hose. Tighten the gate and take drain capacity.