Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
- Transmission
   + Manual box of gear shifting
   - Automatic transmission
      Adjustment of a driving cable of a choice of transfers of AT
      Removal and installation of a driving cable of a choice of transfers of AT
      Removal and installation of assembly of the lever of the selector of transfers
      Adjustment of a driving cable of inclusion of the kick-down mode
      Replacement of a driving cable of inclusion of the kick-down mode
      Removal and installation of a drive of a speedometer
      Replacement of epiploons
      Removal and installation of a cooler of ATF
      The sensor switch of permission of starts/fires of a backing - the general information, removal and installation
      Removal and AT installation
      Major maintenance of AT - the general information
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


escort girl

Adjustment of a driving cable of a choice of transfers of AT


Fastening of a driving cable to a spherical support of the lever of a choice of transfers on transmission

1 — a cable Tip
2 — Sharovy the lever hinge
3 — Lock-nuts of a cover of a cable


 PERFORMANCE ORDER

1. Transfer the lever to the situation "N" (Neutral).
2. For the purpose of ensuring access to the end of a driving cable turned to transmission remove the battery with the pallet and a basic plate (see. Head engine Electric equipment). It is in addition possible to remove also inlet air line (ы) (see. Head of the Power supply system and release).
3. Having hooked a big screw-driver with a flat sting, accurately liberate a cable tip from the spherical hinge of the lever of a choice of transfers on transmission (hold the lever in the chosen situation [N]).
4. Make sure that a tip will screw on a carving of the core of a cable not less than on 5 millimeters.
5. Make sure that the selector lever, no less than the lever of a choice of transfers on transmission, are in provisions N. The tip of a cable should be combined correctly with the spherical hinge of the lever of a choice of transfers so that not to cause shift of the last at connection. In case of need make the corresponding adjustment, rotating a cable tip in the demanded direction (do not forget about the condition stipulated in the previous point). If to achieve demanded result it is not possible, for further adjustment weaken lock-nuts a crêpe of a cover of a cable on its basic arm (see an illustration Fastening of a driving cable to a spherical support of the lever of a choice of transfers on transmission). Displace nuts in the demanded direction, achieving the correct provision of a tip. Do not forget to tighten a nut.
6. Having achieved satisfactory result, strongly fix a cable tip on the spherical hinge of the lever.
7. Establish into place all components acting in film for the purpose of ensuring access.