Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
- Transmission
   + Manual box of gear shifting
   - Automatic transmission
      Adjustment of a driving cable of a choice of transfers of AT
      Removal and installation of a driving cable of a choice of transfers of AT
      Removal and installation of assembly of the lever of the selector of transfers
      Adjustment of a driving cable of inclusion of the kick-down mode
      Replacement of a driving cable of inclusion of the kick-down mode
      Removal and installation of a drive of a speedometer
      Replacement of epiploons
      Removal and installation of a cooler of ATF
      The sensor switch of permission of starts/fires of a backing - the general information, removal and installation
      Removal and AT installation
      Major maintenance of AT - the general information
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Replacement of epiploons

Epiploons of power shafts

See. Replacement of epiploons of RKPP.

Epiploon of a rod of a choice of transfers

 PERFORMANCE ORDER

1. Transfer the selector lever to situation N.
2. For the purpose of ensuring access to the end of a driving cable turned to transmission remove the battery with the pallet and a basic plate (see. Head engine Electric equipment). In case of need remove also inlet air line (ы) (see. Head of the Power supply system and release).
3. Turn out two screws of fastening of a cover of a cable in the arm, then accurately disconnect a tip from the spherical hinge on the end of the lever of a choice of transfers on transmission.

Do not allow change of position of the lever of a choice of transfers after a detachment of a driving cable! As an additional precautionary measure mark position of the lever concerning a transmission case.

4. Give a fixing nut and remove the lever from a pin of a rod of a choice of transfers.
5. Puncture in a face surface of an epiploon pair of small openings. Screw in openings саморезы. Having grasped nippers heads of screws, take an epiploon from the nest.
6. Wipe walls of a nest of an epiploon and a surface of a pin of a rod. In case of need with a fine-grained emery paper remove agnails and the teases, capable to bring to failure of a new epiploon. At detection of serious defects it is necessary to make rod replacement.
7. Grease sponges of a new epiploon with pure impellent oil, then accurately put on an epiploon sealing sponges inside a rod of a choice of transfers (try not to damage sponges). By means of a piece of a pipe of the corresponding diameter plant an epiploon in a nest aflush with a surface of a case of transmission (the opravka should rest only against the firm external region of an epiploon).
8. Put on the lever of a choice of transfers a pin of a rod and tighten a nut of its fastening with demanded effort.
9. Establish a flange of fastening of a cover of a cable on a basic arm on transmission and fix it fixing bolts.
10. Make sure that levers of the selector and a choice of transfers on the former are in situation N, then make adjustment of a cable and its connection to the choice lever (see subitem 4 — 6 in the section Adjustment of a driving cable of a choice of transfers of AT).