Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
- Transmission
   + Manual box of gear shifting
   - Automatic transmission
      Adjustment of a driving cable of a choice of transfers of AT
      Removal and installation of a driving cable of a choice of transfers of AT
      Removal and installation of assembly of the lever of the selector of transfers
      Adjustment of a driving cable of inclusion of the kick-down mode
      Replacement of a driving cable of inclusion of the kick-down mode
      Removal and installation of a drive of a speedometer
      Replacement of epiploons
      Removal and installation of a cooler of ATF
      The sensor switch of permission of starts/fires of a backing - the general information, removal and installation
      Removal and AT installation
      Major maintenance of AT - the general information
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Removal and installation of a cooler of ATF


Details of installation of a cooler of ATF

1 — the Hose of supply of cooling liquid
2 — the Hose of removal of cooling liquid
3 — the Central boat
4 — Assembly of a cooler of ATF


Sealing rings of assembly of a cooler of ATF

1 — the Internal sealing ring
2 — the External sealing ring
3 — the Sealing ring of the central bolt

Removal

 PERFORMANCE ORDER

1. The cooler of ATF is established from above on a transmission case. For the purpose of ensuring access to assembly remove an inlet air line (ы) (see. Head of the Power supply system and release). Turn out three bolts of fastening of a basic arm of hoses, separate an arm from assembly of a cooler and shift it aside.
2. For the purpose of minimization of losses of cooling liquid by special clips or clamps press both coolers of ATF of a hose brought to assembly (see an illustration of the Detail of installation of a cooler of ATF).
3. Weaken fixing collars and disconnect both coolers of a hose brought to assembly. Prepare for collecting spilled cooling liquid. At once collect traces of the spilled liquid and rinse with cold water a cooler and surfaces adjoining to it.
4. Turn out the central bolt (see an illustration of the Detail of installation of a cooler of ATF). also remove cooler assembly about three. Remove from the central bolt the sealing ring put on it. Also remove two sealing rings, established in the basis of assembly of a cooler. All three sealing rings are subject to replacement without fail.

Installation

 PERFORMANCE ORDER

1. Grease new sealing rings with pure transmission liquid and establish them on the regular places on assembly (see an illustration Sealing rings of assembly of a cooler of ATF).
2. Establish cooler assembly on the seat from above on AT case. Track, that the flat edge of assembly appeared located parallel to an interfaced surface of a case. Screw the central bolt and tighten it with demanded effort.
3. Connect to a cooler hoses of an okhladitelny path, fix hoses collars and remove pressing clips/clamps.
4. Establish into place all components acting in film for the purpose of ensuring access.
5. In summary add necessary quantity of a mix of demanded structure in system of cooling and check ATF level (address to Head "Routine maintenance of the car").