Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
- Transmission
   + Manual box of gear shifting
   - Automatic transmission
      Adjustment of a driving cable of a choice of transfers of AT
      Removal and installation of a driving cable of a choice of transfers of AT
      Removal and installation of assembly of the lever of the selector of transfers
      Adjustment of a driving cable of inclusion of the kick-down mode
      Replacement of a driving cable of inclusion of the kick-down mode
      Removal and installation of a drive of a speedometer
      Replacement of epiploons
      Removal and installation of a cooler of ATF
      The sensor switch of permission of starts/fires of a backing - the general information, removal and installation
      Removal and AT installation
      Major maintenance of AT - the general information
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


Removal and installation of assembly of the lever of the selector of transfers

Removal

 PERFORMANCE ORDER

1. Prop up protivootkatny boots back wheels, then поддомкратьте a front of the car and establish it on props. Transfer the selector lever to situation N.
2. Remove the thermofilter (ы) systems of production of the fulfilled gases for the purpose of ensuring access to the basis of assembly of the lever of the selector (see. Head of the Power supply system and release).
3. Execute the procedures described in the subsection "Removal", subitem 6 — 8, the section Removal and installation of a driving cable of a choice of transfers of AT.
4. Under the car disconnect lever assembly from the bottom of the car and lower it down.
5. Having hooked, remove from the basis of the lever and shift along a driving cable a rubber protective cover.
6. Weaken a nut of fastening of a cover of a cable and release a fixing clamp. Accurately separate a cable tip from the spherical hinge in the lever basis, then take assembly of the last from under the car.

Installation

 PERFORMANCE ORDER

1. Execute the procedures described in in the subsection "Installation", subitem 1 — 6, the section Removal and installation of a driving cable of a choice of transfers of AT.
2. Establish into place the thermofilter (ы) systems of production of the fulfilled gases (see. Head of the Power supply system and release), then lower the car on the earth.
3. In summary check correctness of adjustment of a cable of a drive of gear shifting, in case of need make the corresponding adjustment (see. Adjustment of a driving cable of a choice of transfers of AT).