Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
- Coupling
   Adjustment of a drive of coupling
   Removal and installation of a cable of a drive of coupling
   Removal and installation of a pedal of coupling
   Removal, check of a condition and installation of assembly of coupling
   Removal, check of a condition of components and installation of the mechanism of switching off of coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes



Removal and installation of a cable of a drive of coupling

Removal

 PERFORMANCE ORDER

1. In case of need for the purpose of ensuring access remove an air purifier sleeve, or components of its casing (see. Head of the Power supply system and release). Also in case of need remove the storage battery with the pallet and a basic arm (see. Start and charge systems).
2. On models with a left foreign steering remove the tank of hydraulic liquid (see. Head Uniform hydraulic system) also lay it in suitable capacity.

3. In an impellent compartment completely weaken a lock-nut, then an adjusting nut on the end of a driving cable turned to transmission, then liberate cable assembly from a transmission case.





4. Access to a coupling pedal in salon of the car is extremely limited, therefore originators of the real Management recommend to remove the dashboard previously. In principle, will enough remove only bottom panel of a felt upholstery.

5. By means of a screw-driver release a plastic clamp at once under the top part of a pedal of coupling and disconnect a cable from a pedal.

6. Return to an impellent compartment and liberate directing a cable from a partition of an impellent compartment. Having pulled a cable forward, liberate it from the remained clamps and directing. Try to remember a route of laying of a cable, then take it from an impellent compartment.

7. Attentively examine a cable on existence of traces of damage of a cover and wear of tips. Estimate a core condition. Make sure of serviceability of functioning of hummock assembly. The core should slide freely in a cover. Remember that cable regularly functioning out of the car can give out refusals after installation it in regular situation. In case of detection of the slightest defects or signs of wear make replacement of hummock assembly.

Installation

 PERFORMANCE ORDER

1. Grease clamps of tips with universal greasing, then pass a cable through a partition of an impellent compartment.



2. Having enclosed under a pedal wooden whetstone suitable on the size or the tool, fix a coupling pedal in the released situation (at the end of a working course).

3. Fill a cable tip in a plastic clip and track reliability of its fixing.

For simplification of landing of a tip in a clamp ask the assistant to wring out the cable core for a tip from transmission.

4. In an impellent compartment fill a cable in a case of a transmission and connect it to the lever of switching off of coupling. Screw adjusting and kontryashchy nuts.
5. Execute cable adjustment (see. Adjustment of a drive of coupling) also make sure of serviceability of functioning of a pedal of coupling.
6. Establish into place a felt upholstery, or the dashboard, and on models with a left foreign steering also the tank of hydraulic liquid (see. Head Uniform hydraulic system).
7. Establish the battery and components of an airintaking path.