Citroen Xantia

since 1993 of release

Repair and car operation


Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Uniform hydraulic system
   General information and precautionary measures
   Сбрасывание / forcing of hydraulic pressure and system filling
   The pump of a high pressure - general information, removal and installation
   Regulator of hydraulic pressure - general information, removal and installation
   The tank of hydraulic liquid - general information, removal and installation
   Receivers of hydraulic liquid - general information, removal and installation
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

The tank of hydraulic liquid - general information, removal and installation

General information


Tank of hydraulic liquid

1 — the Submitting hose from the pump of a high pressure
2 — the Returnable hose from a pressure regulator
3 — the Returnable hose from the power steering cylinder
4 — the Hose of return of hydraulic liquid from proof-readers of a road gleam, cylinders of a suspension bracket and a safety valve

5 — the Hose of return of liquid from the proof-reader of a road gleam
6 — the Hose of return of liquid from system ABS/antiprobuksovochnoy modulators
7 — the Hose of return of liquid from the power steering valve
8 — the Ventilating hose

The tank of hydraulic liquid represents the metal container equipped with an observation port of control of level of liquid. The container is divided inside by the plates calming liquid and preventing formation of vortical streams. The tank is located in the right forward corner of an impellent compartment. Air removal from the tank is made on a hose in the filter located under an assembly bracket.

For check of level of hydraulic liquid it is necessary to start the engine and to transfer a control lever the provision of a suspension bracket to the situation "Maximum". The yellow label on a control float in an observation port should settle down between two red risks designating minimum and maximum admissible values of level of liquid.

Various hydraulic hoses are connected to the tank (see an illustration the Tank of hydraulic liquid) which main part is made by hoses of return of liquid in the tank from various actuation mechanisms of system. The tank equipment directly depends on a car complete set.

Removal

 PERFORMANCE ORDER

1. Dump pressure in hydraulic system (see. General information and precautionary measures).
2. Make sure that the control lever is established by the provision of a suspension bracket in the situation "Minimum", then slowly turn a steering wheel from an emphasis against the stop for dumping of residual pressure. Thus the most part of hydraulic liquid should flow in the tank.
3. Liberate hydraulic hoses from arms on a tank wall.

4. Disconnect electroconducting from the indicator of level of liquid.

5. Release a collar of fastening of the central section to the top part of the tank.
6. Remove the central section, then wrap up it in polyethylene and put aside. In an ideal the central section should be placed in suitable capacity in order to avoid dirt hit in it.

Quite good way of protection of the central section is its room in the cut-off plastic bottle from under mineral water.

7. Give two fixing nuts and take tank assembly from an impellent compartment.

Installation

Installation is made upside-down. Track correctness of laying and connection of hydraulic lines, and also behind correctness of placement of the basis of the tank in the directing.

In summary fill in in system hydraulic liquid (address to Head Routine maintenance).