Citroen Xantia

since 1993 of release

Repair and car operation


Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
- Coupling
   Adjustment of a drive of coupling
   Removal and installation of a cable of a drive of coupling
   Removal and installation of a pedal of coupling
   Removal, check of a condition and installation of assembly of coupling
   Removal, check of a condition of components and installation of the mechanism of switching off of coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

Removal and installation of a pedal of coupling

Removal

 PERFORMANCE ORDER

1. Disconnect a driving cable from the top part of a pedal of coupling (see. Removal and installation of a cable of a drive of coupling). For the purpose of ensuring the best access to a pedal remove the dashboard.
2. Having remembered adjusting situation, disconnect from a pedal a returnable spring.

3. Give a nut and take an axial bolt. Remove pedal assembly from an arm, take the remote plug, a spring and axial plugs.

4. Check the remote plug and springs on existence of signs of wear and mechanical damages. Replace defective components.

Installation

Installation is made upside-down. Pay attention to the next moments:
   a) Before installation grease with dense greasing a shaft of an axial bolt;
   b) Track correctness of installation of a pedal spring;
   c) In summary do not forget to make adjustment of a cable of a drive of coupling (see. Adjustment of a drive of coupling).