|
1. Disconnect a negative wire from the battery.
2. Remove casings of a steering column (address to Head the Body and salon furnish).
3. Open a cover of the assembly block for the purpose of ensuring access to the screw of fastening of the angular panel of furnish of "Torpedo" from the driver's party of the car. |
|
4. Turn out the top and bottom fixing screws, delay the panel forward and disconnect from it electroconducting. Try to remember an order of connection of contact sockets. Remove the panel. |
|
|
5. Turn out three screws / release clamps of fastening of the panel of the switches located under an instrument guard. Liberate the left side of the panel from "Torpedo", pull assembly on itself and disconnect electroconducting from switches. Try to remember an order of connection of contact sockets. Remove the panel.
6. Take from the dashboard an ashtray.
7. Turn out two bottom fixing screws, having accurately hooked a small screw-driver, release clamps and remove facing of control panels by radio tape recorder/heater functioning.
8. Having hooked a small screw-driver, remove from the dashboard deflectors central ventilating nozzles. |
|
9. Turn out two fixing screws and take from the dashboard a casing snuffled. Disconnect electroconducting from "Torpedo" of switches located in the central part, hours and, at the corresponding complete set, a control lamp anticreeping the air temperature alarm system/sensor in car salon. |
|
|
10. From the back party of the panel release clamps and вытолкните outside hours. |
|